Ars Trunk Group To Route Number Assignment - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________
1-14-04 ARS Trunk Group to Route Number
Assignment
General Description
Use this Memory Block to specify whether a Trunk Group, Route Advance Block, or
ICM is used for each Route assignment.
Display
R o u t e
D a t a
N o . N o .
0 4 / 0 1 = N O R M A L
T I M E
Settings
LK 1 LK 2
NORMAL TKGP
(Originate) (01~32)
Programming Procedures
1 Go off-line.
K D
2 Press LK1 + LK14 +
3 Press the corresponding CO/PBX line key to change the Setting Data 1 option.
Use the following to enter data:
K I
~ to select Data Setting Data 2 Trunk Group Number (01~32) or Setting Data 2 RAB (01~32).
J
t o move cursor left
L
G
t o move cursor right
4 Press to write the data. The next Route No. is displayed.
5 Repeat steps 3 and 4 for each Route No. The next Memory Block is displayed.
6 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-1-30 Route Advance Block Assignment
1-8-08 Class of Service (Station) Feature Selection 2
1-14-00 ARS Allow/Deny Selection
___________________________________________________________________________________
2 - 292
S e t t i n g
S e t t i n g
D a t a 2
D a t a 1
D I S P L A Y
LK 3 LK 4 LK 5
RAB
(01~32)
t o access the Memory Block.
E
to go back on-line.
LK 6 LK 7 LK 8
ICM
Elite IPK
System Mode
1
Submode
14
Data No.
04
PC Programming
+AB
The shaded
selection is the
default.
Memory Blocks