Caller Id Display Assignment For System Mode - NEC Electra Elite IPK Programing Manual

Elite IPK
___________________________________________________________________________________
1-1-78 Caller ID Display Assignment for
System Mode
General Description
Use this Memory Block to assign up to 15 Multiline Terminals to display ANI/Caller ID
Indication for normal incoming CO/PBX calls or CO/PBX calls ringing a Call Arrival
(CAR) key.
Display
D a t a
N o .
7 8 : C A L L I D
T I M E
Programming Procedures
1 Go off-line.
G H
2 Press LK1 + LK1 +
3 Use the dial pad to enter Entry No. 01 and Tel Port No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K I
G
~ to enter numeric data
4 Press to write the data and advance to the next Entry No. After each tel port No. is selected, press
total of 15 entries can be made. After the last data is entered, the next Memory Block is displayed.
5 Program the next Memory Block or press
1. To display ANI/Caller ID Indication for normal incoming and CAR incoming calls, Caller ID Indication and Ring
Assignment must be programmed.
2. Fifteen Multiline Terminals can be assigned system-wide to display ANI/Caller ID.
3. A sixteenth terminal can be assigned to display ANI/Caller ID using another Memory Block.
___________________________________________________________________________________
Programming Manual
T e l P o r t N o .
( 0 0 ~ 9 9
E n t r y
A 0 ~ A 9
N o .
B 0 ~ B 9
T i t l e 0 1 ~ 1 5
0 1 =
D I S P L A Y
to access the Memory Block.
E
to go back on-line.
C O )
Notes
Document Revision 1
System Mode
Submode
Data No.
PC Programming
Default Values
Not specified
G
1
1
78
+AI
again. A
2 - 89