Disa Id Code Assignment - NEC Electra Elite IPK Programing Manual

Elite IPK
___________________________________________________________________________________
1-9-00

DISA ID Code Assignment

General Description
Use this Memory Block to specify the Direct Inward System Access (DISA) ID Code
number.
Display
I D B u f f e r
N o . D a t a
( 0 1 ~ C 0 ) N o .
0 1 / 0 0 : C O D E
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK9 to access the Memory Block.
3 Use the dial pad to enter the data.
Setting Data:
2-digit DISA ID Code: 00~99 (00 no data)
3-digit DISA ID Code: 000~999 (000 no data)
4-digit DISA ID Code: 0000~9999 (0000 no data)
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
D
K I
~ to enter numeric data
B
to access the next assigned ID buffer number or cycle back to 1
+ 1, 2, 3 = A, B, or C for Port Number
ID Buffer Number:
01~99
A0~A9
B0~B9
G
C0
4 Press to write the data. Memory Block 1-9-02 is displayed.
5 Repeat Steps 3 and 4 for each remaining sequential ID Buffer No. displayed after each password choice is made in Memory
Block 1-9-02.
1. Assign 000 (No Data) for stations that are not installed or stations that are denied DISA access.
2. This Memory Block cycles through ID Buffer Nos. alternating with Memory Block 1-9-02 password specification
for each Buffer No.
___________________________________________________________________________________
Programming Manual
S e t t i n g
D a t a
T i t l e
= 0 0 0 0
D I S P L A Y
Default Values
Notes
Document Revision 1
System Mode
Submode
Data No.
PC Programming
If DISA ID Code is assigned as 2-digit:
ID Buffer Number 01~10 = DISA ID Code
10~19
ID Buffer Number 11~20 = DISA ID Code
20~29, etc.
If DISA ID Code is assigned as 3-digit:
ID Buffer Number 01~C0 = DISA ID
Code 100~219
If DISA ID Code is assigned as 4-digit:
ID Buffer Number 01~10 = DISA ID Code
1000~1009
ID Buffer Number 11~20 = DISA ID Code
1010~1019, etc.
1
9
00
+BD
2 - 231