Start Time Selection - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________
1-1-05

Start Time Selection

General Description
Use this Memory Block to specify the time after dialing before the system starts the
Elapsed Call Time.
Display
D a t a
N o .
0 5 : C A L L S T A R T
T I M E
Settings
LK 1 LK 2
10s 20s
Programming Procedures
1 Go off-line.
K E
2 Press LK1 + LK1 +
G
3 Press the corresponding CO/PBX line key to change the data option.
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-5-25 SMDR Valid Call Time Assignment
This time is used for the features with functions described below:
Elapsed Call Time: The time after dialing before the Elapsed Call Time is started and displayed on a Multiline
Terminal.
SMDR Start Time: The time needed after dialing before the SMDR Valid Call Time is started. Refer to Memory
Block 1-5-25 (SMDR Valid Call Time Assignment). For outgoing calls, both Elapsed Call Time and SMDR Valid
Call Time must elapse before a call record is generated.
___________________________________________________________________________________
2 - 8
S e t t i n g
D a t a
T i t l e
1 0 s
D I S P L A Y
LK 3 LK 4 LK 5
30s 40s 50s
to access the Memory Block.
E
to go back on-line.
LK 6 LK 7
60s 70s
Notes
Elite IPK
System Mode
1
Submode
1
Data No.
05
PC Programming
+BM
LK 8
The shaded
2s
selection is the
default.
Memory Blocks