Slt Hookflash Signal Selection - NEC Electra Elite IPK Programing Manual

Document Revison 1
___________________________________________________________________________________
1-3-02

SLT Hookflash Signal Selection

General Description
Use this Memory Block to specify whether a line is held internally, or when behind a
PBX, a hookflash (HF) signal is sent to the line when a Single Line Telephone user
performs a hookflash.
Display
D a t a
N o .
0 2 : S I G N A L
T I M E
Settings
LK 1 LK 2
HOLD FLASH
Programming Procedures
1 Go off-line.
K B
2 Press LK1 + LK3 +
G
3 Press the corresponding CO/PBX line key to change the data option.
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-1-02 Hookflash Time Selection
4-24 SLT Hookflash Assignment
1. When Hold is specified, the CO/PBX line is put on Exclusive Hold.
2. When Hold is selected, the PBX/CTX line can receive the hookflash signal using Access Code 6# (default).
3. When Flash is specified, press the hookswitch to send the hookflash signal to the PBX/CTX line.
___________________________________________________________________________________
2 - 120
S e t t i n g
T i t l e
D a t a
H 0 L D
D I S P L A Y
LK 3 LK 4 LK 5
t o access the Memory Block.
E
to go back on-line.
LK 6 LK 7
Notes
System Mode
1
Submode
3
Data No.
02
PC Programming
+BTI
LK 8 The shaded
selection is the
default.
Memory Blocks
Elite IPK