Automated Attendant Delay Announcement Disconnect Time Selection - NEC Electra Elite IPK Programing Manual

Elite IPK
___________________________________________________________________________________
1-4-20 Automated Attendant Delay
Announcement Disconnect Time
Selection
General Description
Use this Memory Block to establish the time, in seconds or minutes, the Automated
Attendant rings the station before disconnecting the caller. This Memory Block only
applies when the Automated Attendant is set to Delay Announcement Mode.
Display
D a t a
N o .
2 0 : 2 N D
T I M E
Settings
Page 1
LK 1 LK 2
0s 10s
Page 2
LK 1 LK 2
5m 10m
Programming Procedures
1 Go off-line.
J J B K
2 Press LK1 + LK4 +
3 Press the corresponding CO/PBX line key to change the disconnect time.
C
Example: To change 30 seconds to 10 seconds, press CO/PBX LK2.
G
Press
4 Press to write the selected data and advance to the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-4-18 Automated Attendant Delay Announcement Assignment
1-4-19 Automated Attendant 1
___________________________________________________________________________________
Programming Manual
S e t t i n g
P a g e
T i t l e
D a t a
I N T R 3 0 s | 1
D I S P L A Y
LK 3 LK 4
20s 30s
LK 3 LK 4
20m
t o access the Memory Block.
to toggle between pages.
E
to go back on-line.
st nd
to 2 Delay Announcement Interval Time Selection
LK 5 LK 6
1m 2m
LK 5 LK 6
Document Revision 1
System Mode
PC Programming
LK 7 LK 8
3m 4m
The shaded
selection is the
default.
LK 7 LK 8
Default Values
30 seconds
1
Submode
4
Data No.
20
+ AU
2 - 149