Basic Touchscreen Operations; Databar Status Symbols - Raymarine a67 Wi-Fi Installation And Operation Instructions Manual

6.18 Basic touchscreen operations

Placing and moving the cursor using
touch
To place or move the cursor around the screen on a touchscreen
multifunction display follow the steps below.
1. Touch the screen at any position on the screen to place the
cursor there.
Touchscreen lock
You can lock the touchscreen to prevent accidental use.
This only applies to HybridTouch displays.
For example, locking the touchscreen is particularly useful in
rough water or weather conditions.
The touchscreen is locked from the homescreen. An icon in the
homescreen indicates the lock status:
You must use the UniControl to unlock the touchscreen.
Locking the touchscreen
This only applies to HybridTouch displays.
With the homescreen displayed:
1. Select the Touch Lock icon.
It changes color to indicate that the touchscreen is disabled.
All functions are still available using the buttons and
UniControl.
Unlocking the touchscreen
This only applies to HybridTouch displays.
With the homescreen displayed:
1. Use the UniControl to highlight the Touch Lock icon.
2. Press the OK button.
The Touchscreen is enabled.
Getting started
Touchscreen is unlocked.
Touchscreen is locked. All functions
remain available using physical buttons.

6.19 Databar status symbols

The status symbols on the databar confirm whether the
appropriate connections to your system have been made.
The symbols show the status for the following:
• Radar scanner.
• AIS receiver / transceiver.
• Sonar module.
• GPS receiver.
• Autopilot.
Radar scanner status symbols
The radar scanner power mode status is indicated in the databar.
Radar
power
Symbol mode
Transmit
(TX)
Standby
(STBY)
Off
Timed
Transmit
AIS status symbols
AIS status is indicated by a symbol in the databar.
Symbol Description
AIS unit is switched on and operating.
AIS currently unavailable.
AIS unit is switched off, or not connected.
AIS unit is in Silent Mode.
AIS unit is in Silent Mode, with active alarms.
Description
Rotating icon, signifying that the scanner
is on and transmitting. When SCANNER
is set to ON, select this mode to activate
the scanner. This is the usual mode of
operation.
Static icon, indicating that the scanner is
on but not transmitting, and the antenna is
not rotating. The scanner does not transmit
and the radar data is removed from the
screen. This is a power-save mode used
when the radar is not needed for short
time periods. When you return to transmit
mode, the magnetron does not need to
warm up again. This is the default mode.
Scanner powered off when radar not
required, but display is in use for other
applications, such as the chart. When
selected, the system counts down. During
this time you cannot re-power the scanner.
Scanner switches between on/transmitting,
and standby mode. Scanner goes into
power save mode when constant use of
radar is not required.
87