Raymarine a67 Wi-Fi Installation And Operation Instructions Manual page 45

Radar connected using crossover coupler
Radar cable extension
For longer cable runs a radar power and data digital cable extension is required.
1. Radar extension cable.
2. Radar power and data digital cable.
3. Raymarine network switch (or crossover coupler if connecting radar directly to display).
4. RayNet cable (or RayNet to SeaTalk
Note: The extension cable connects to the radar scanner.
Note: The power connection is NOT shown in the diagram. If using an Open Array scanner a VCM (Voltage Converter Module)
must be connected between the scanner and the power supply.
Cables and connections
1
3
1 2
hs cable if connecting via crossover coupler).
1. Radar scanner
2. Multifunction display rear connector panel.
3. SeaTalk hs crossover coupler.
4. RayNet to SeaTalk
5. Connection to power supply — Open array scanners
require a VCM (Voltage Converter Module).
Note: The connector on the free end of the radar cable does
NOT have a locking mechanism.
D12253-1
3
4
hs network cable.
D12254-1
45