Wan - Edimax BR-6215NRg User Manual

Parameters
Host Address
Port
Enabled
Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other advance
sections or start using the router (with the advance settings in place)

2.2 WAN

Use the WAN Settings screen if you have already configured the Quick Setup Wizard section and you would like to
change your Internet connection type. The WAN Settings screen allows to specify the type of WAN port connect you
want to establish with your ISP. The WAN settings offer the following selections for the router's WAN port, Dynamic IP,
Static IP Address, PPPoE, PPTP, L2TP, Telstra Big Pond, DNS and DDNS.
This is the IP address of the host in the Internet that will have
management/configuration access to the Broadband router from a remote site. This
means if you are at home and your home IP address has been designated the Remote
Management host IP address for this router (located in your company office), then you
are able to configure this router from your home. If the Host Address is left 0.0.0.0 this
means anyone can access the router's web-based configuration from a remote
location, providing they know the password.
Click the Enabled box to enable the Remote Management function.
Note: When you want to access the web-based management from a remote site, you
must enter the router's WAN IP address (e.g. 10.0.0.1) into your web-browser followed
by port number 8080, e.g. 10.0.0.1:8080 (see below). You'll also need to know the
password set in the Password Setting screen in order to access the router's web-
based management.
The port number of remote management web interface.
Select "Enabled" to enable the remote management function.
22
Description