Scanning Sequence Examples; Errors While Scanning; Imaging Preferences Parameter Defaults - Motorola Symbol MT2070 User Manual

6 - 2 Symbol MT2070/MT2090 User Guide

Scanning Sequence Examples

In most cases scanning one bar code sets the parameter value. For example, to disable image capture
illumination, scan the Disable Image Capture Illumination bar code under
6-5. The device issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

Imaging Preferences Parameter Defaults

Table 6-1 lists the defaults for imaging preferences parameters. Scan the appropriate bar codes in this guide.
These new values replace the standard default values in memory. To recall the default parameter values, scan the
Set Default Parameter on page
NOTE See
miscellaneous default parameters.
Imaging Preferences Parameter Defaults
Table 6-1
Parameter
Imaging Preferences
Operational Modes
Image Capture Illumination
Snapshot Mode Timeout
Snapshot Aiming Pattern
Image Cropping
Crop to Pixel Addresses
Image Brightness (Target White)
JPEG Quality and Size Value
Image File Format Selection
Signature Capture
Signature Capture Image File Format
Selection
5-4.
Appendix A, Standard Default Parameters
Parameter
Number
N/A
F0h 69h
F0h 43h
F0h 2Ch
F0h 2Dh
F4h F0h 3Bh;
F4h F0h 3Ch;
F4h F0h 3Dh;
F4h F0h 3Eh
F0h 86h
F0h 31h
F0h 30h
5Dh
F0h 39h
Image Capture Illumination on page
for all user preferences, hosts, symbologies, and
Default
N/A
Enable
0 (30 seconds)
Enable
Disable
0 top, 0 left, 1023 bottom, 1279
right
180
65
JPEG
Disable
JPEG
Page Number
6-4
6-5
6-6
6-6
6-7
6-8
6-9
6-9
6-10
6-11
6-12