4 - 2
DS6708 Digital Scanner Product Reference Guide
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code listed under
issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Timeout or Data Transmission Formats, require scanning
several bar codes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences/Miscellaneous Options Parameter Defaults
Table 4-1
lists defaults for user preferences parameters. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Configure the digital scanner using the 123Scan
NOTE See
miscellaneous default parameters.
User Preferences Parameter Defaults
Table 4-1
User Preferences
Set Default Parameter
Parameter Scanning
Beeper Tone
Beeper Volume
Suppress Power-up Beeps
Power Mode
Time Delay to Low Power Mode
Trigger Mode
Picklist Mode
Presentation Mode Time Delay
Mobile Phone/Display Mode
Appendix A, Standard Default Parameters
Parameter
Beeper Tone on page
Set Default Parameter on page
2
configuration program (see
for all user preferences, hosts, symbologies, and
Parameter
Default
Number
Restore Defaults
ECh
Enable
91h
Medium
8Ch
High
F1h D1h
Do not suppress
80h
Continuous On
92h
1 Minute
8Ah
Auto Aim
F0h 92h
Disabled Always
F1h E9h
Disable (3 seconds for
scanner with base)
F1h CCh
Disable
4-5. The digital scanner
4-4.
Chapter 12,
123Scan2).
Page
Number
4-4
4-5
4-5
4-6
4-6
4-7
4-8
4-9
4-10
4-11
4-13