Table of Contents
Advertisement
1-6
ii)
Change the screw A, which connects the throttle valve with the link for the screw 4x20 in the
kit.
Screw A 4x20:
93892-04020-10
[CAUTION}
•
Remove the screw A with a screwdriver, pulling it upwards.
How to exchange jet needles
i)
Open up the throttle and the throttle valve all the way
ii)
Remove the screw and slide to remove the link arm from the throttle valve, then turn down
the throttle valve.
iii)
Remove the valve plate and the jet needle from the throttle valve.
iv)
Assemble the parts by the reverse process.
[CAUTION}
•
A washer must be fitted between the bar clip and the throttle valve.
3. Solenoid valve
i)
Remove the air jet control tube A from the solenoid valve and the tube B from the '+ joint',
thus, they are exposed in the open air.
ii)
Change the 'Y joint' for the kit.
'Y joint':
16180-NKD-970
iii)
Cut the end of the air vent 'tube D' 20mm.
iv)
Cut the air jet control 'tube E' 20mm, then connect it with the 'Y joint'.
Hide quick links:
Advertisement
Chapters
Table of Contents
