Front Brake Pads - Honda 1994 NSR 250 SP Setup Manual

1-14

11. FRONT BRAKE PADS

1. Exchanging the front brake pads
i) Remove the pad securing pins of the front callipers and exchange it for the kit.
For racing: Z22W 45105-NKD-970
For endurance: TT2501
ii) When exchanging the pads, it is easy to remove pins with the pads pushed towards the centre of the
wheel. Also, when setting new pads, widen the piston of the calliper makes it easy to set.
[CAUTION]
•
Detach the dust cover in the interests of cooling the callipers and pads.
•
Ensure that pads are exchanged in a set
•
Ensure that abrasion of the pads is measured before using.
•
The pads Z22W for racing is abraded faster than TT2501 owing to its importance of controlling.
•
Exchange pad securing pins regularly as well as pads.
•
When widening the calliper piston, ensure that the fluid in the breather tank does not spurt.
12. REAR SETS
1. Removing the standard rear sets.
i) Remove the gear shift linkage from the shift spindle shaft take off the L. rear set bolt and
detach the foot peg hanger
ii) Remove the R. rear set bolt and detach the foot peg hanger.
iii) Remove the joint pin of the rear brake master cylinder then the master cylinder fastening
bolt and detach the master cylinder from the foot peg hangers.
45105-MN8-006