Steering Damper Set - Honda 1994 NSR 250 SP Setup Manual

1-12

9. STEERING DAMPER SET

1. Steering stopper
•
Adjust the angle of the steering of the standard machine. (Adjust the width of the handle bars as
the angle narrows)
i) Detach the front brake clamp from the front stem.
ii) Fit the steering stopper.
Tightening torque: 1.2kgf.m
2. Installing the steering damper.
i) Loosen the steering stem nut/front fork bolt, then remove the top yoke.
ii) Loosen the bolt of the handle bar and remove R/L.
iii) Fix the steering damper stay.
iv) Cut the stopper boss of the handle bar, attach it to the front fork and fasten the bolt
temporarily.
v) Fit the top yoke.
Tightening torque
Steering stem nut: 10.5kgf.m
Handle bar bolt: 2.3kgf.m
vi) Fix the holder to the steering damper, then fix it to the damper stay.
Tightening torque
6mm bolt: 1.2kgf.m
vii) Check the movement of the steering damper turning it on both sides, then fasten the bolt of
the steering damper stay so that the bearing moves smoothly.
Tightening torque: 6mm bolt 1.0 kgf.m
8mm bolt: 2.0kgf.m