Table of Contents
Advertisement
1-8
4.
CARBURETTOR BOX SET
1. Installing the carburettor box set.
i)
Fit the air guide plate to the radiator with tie wrap.
ii)
Remove the standard filter / air box, then install the carburettor box.
iii)
Fix the wiring loom with tie wrap.
iv)
Set the carburettor insulator band R/L like '/ \'.
v)
Pass the throttle cable through the hole on the box and fix it to the carburettor, install the
coke cable the same way.
vi)
Insert the carburettor in the insulator (heat shield)
vii)
Tighten the carburettor insulator band through the holes on both sides of the box with a
screwdriver.
viii)
Ensure that the '#100 jet' of the 'Y joint' is fixed to the No. 1 solenoid. (#50 jet is fixed to No.
2 solenoid).
ix)
Insert the tube in the 'Y joint', then install the body of the carburettor.
[CAUTION]
•
When fixing parts with tie wrap, ensure that the fasteners of the guide plate/carburettor box have
been set.
•
When you find it difficult to fasten, attach your fingers from the back of the box and set fasteners
properly.
•
When installing the air guide plate to the standard radiator, ensure that there is an adequate gap
between the plate and the frame body.
•
Fix the No.2 ignition coil with the coil stay in the kit as illustrated.
Ignition coil stay:
36197-NKD-970
Hide quick links:
Advertisement
Chapters
Table of Contents
