1-5
3. SETTING UP THE CARBURETTOR
(Parts to be modified)
1. 2-Stroke oil feed pipes
•
Remove the tubes of the 2-Stroke oil feed pipes, apply adhesive to the caps and fix it to the
pipes.
Caps: 16097-ME9-671
•
Alternatively, cut the tubes of 2-Stroke oil feed pipes by approximately 20mm. Apply adhesive to
aluminium caps (the cone plug 4x5) and insert them into the pipes.
Cone plugs 4x5: 96205-04005
2. Overflow drain tube
•
Remove the overflow drain tube, then fix the cap in the kit.
Cap:
16215-MV4-000
(Parts to be exchanged)
1. Power jet, needle jet holder
•
Remove the front chamber of the carburettor, then exchange the power jet and the needle jet
holder for the kit.
Needle jet holder:
16165-NKD-970
Tightening torque: 0.17kgf.cm
2. Jet needle
i)
Change the jet needle for the kit.
[CAUTION]
•
The jet needle in the kit must be used with the valve plate / the valve plate spring.
Valve plate:
16092-NKD-970
Valve plate spring:
16050-NKD-970