Enter The Radio Settings; Enter The Pari - Avaya DECT R4 Installation Manual

8.4.12 Enter the Radio Settings

Having been configured as the master base station, the radio aspect of the base station can be configured. Note that IP
Office does not support use of a standby master base station.
1. In the left-hand panel select DECT. Select the Radio tab.
2. Set the following values:
· Name
Set this to match the System Name set on the DECT | System tab.
· Password
Set this to match the Password set on the DECT | System tab.
· Master IP Address
Set the address 127.0.0.1 for the base station to refer to itself. (Alternatively set this to match the IP address
assigned to the base station on the LAN | IP tab).
3. Click OK.
· The message Reset required! is displayed. At this stage further changes are required so do not reset the base
station.

8.4.13 Enter the PARI

1. In the left-hand panel select DECT. Select the PARI tab.
2. Enter a value between 1 and 35. This value must be unique from any other DECT R4 master base station in the
area.
3. Click OK.
DECT R4
IP Office Release 7.0
Non-Provisioned Installation: Master Base Station Configuration
15-601047 Issue 03a (21 February 2011)
Page 139