Unpacking; Setting Up The Cradle; Connecting To A Host - Symbol P370 Keyless Reference Manual
Rf scanners
Hide thumbs
Also See for P370 Keyless:
- Product reference manual (202 pages) ,
- Quick reference manual (17 pages) ,
- Manual (17 pages)
Table of Contents
Advertisement
Unpacking
Remove the scanner from its packing and inspect it for damage. If the scanner was
damaged in transit, call one of the telephone numbers listed in the section
Center
on page xi. KEEP THE PACKING. It is the approved shipping container and should
be used if you ever need to return your equipment for servicing.
Setting Up the Cradle
The basic steps to set up the cradle are listed below and described in more detail in the
following sections.
•
connecting the cradle to a host
•
mounting the cradle, if desired
•
pairing the scanner to the cradle.
Connecting to a Host
With some host types, the scanner is unable to answer host terminal polls if the appropriate
host type is not selected. This may result in an error message generated by the host. To
correct this situation, select the proper parameter set and initialize the host terminal. See
Chapter 4, Parameter Menus
There are two basic host communications options available:
•
using an RS-232 cable
•
using a Synapse cable.
RS-232 Connection
1. Make sure all host devices are powered down.
2. Plug the connector at the end of the cradle's cable into the appropriate RS-232
receiving port on the host device.
for more information.
Getting Started
Symbol Support
1-3
Advertisement
Table of Contents
