Automatic Transmission; Fluid; Automatic Transmission Fluid - Hummer 2010 H3 Owner's Manual

Automobile
Hide thumbs Also See for 2010 H3:
Table of Contents

Advertisement

10-12
Vehicle Care
After changing the engine oil, reset
the system:
1. Turn the ignition key to ON/RUN
with the engine off.
2. Press and release the stem
in the lower center of the
instrument cluster until the OIL
LIFE message is displayed.
3. Once the alternating Oil Life
and Reset messages appear,
press and hold the stem until
several beeps sound. This
confirms that the oil life system
has been reset.
4. Turn the key to LOCK/OFF.
If the Change Oil message
comes on again and stays on for
30 seconds at the next ignition
cycle, it did not reset. The system
needs to be reset again.
Ofrecido por www.electromanuales.com
What to Do with Used Oil
Used engine oil contains certain
elements that can be unhealthy for
your skin and could even cause
cancer. Do not let used oil stay on
your skin for very long. Clean your
skin and nails with soap and water,
or a good hand cleaner. Wash or
properly dispose of clothing or rags
containing used engine oil. See the
manufacturer's warnings about the
use and disposal of oil products.
Used oil can be a threat to the
environment. If you change your
own oil, be sure to drain all the oil
from the filter before disposal. Never
dispose of oil by putting it in the
trash, pouring it on the ground, into
sewers, or into streams or bodies of
water. Recycle it by taking it to a
place that collects used oil.

Automatic Transmission

Fluid

When to Check and Change

Automatic Transmission Fluid

A good time to check the automatic
transmission fluid level is when the
engine oil is changed.
Change the fluid and filter at the
intervals listed in Scheduled
Maintenance on page 11 2, and be
sure to use the transmission fluid
listed in Recommended Fluids and
Lubricants on page 11 8.
How to Check Automatic
Transmission Fluid
Because this operation can be a
little difficult, you may choose to
have this done at the dealer service
department.
If adding it yourself, be sure to
follow all the instructions here,
or there could be a false reading on
the dipstick.

Advertisement

Table of Contents
loading

This manual is also suitable for:

H3t 2010

Table of Contents