Table of Contents
Advertisement
Ofrecido por www.electromanuales.com
3. Say the entire number without
pausing.
If the system recognizes
the number, it responds
with OK, Dialing and dials
the number.
If the system does not
recognize the number, it
confirms the numbers
followed by a tone. If the
number is correct, say
Yes . The system responds
with OK, Dialing and dials
the number. If the number
is not correct, say No .
The system will ask for the
number to be re entered.
Using the Digit Dial Command
1. Press and release
. The
system responds with Ready
followed by a tone.
2. Say Digit Dial . The system
responds with Digit dial using
<phone name>, please say the
first digit to dial followed by
a tone.
3. Say the digits to be dialed one at
a time. Following each digit, the
system will repeat back the digit
it heard followed by a tone.
Infotainment System
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say Dial . The
system responds with OK,
Dialing and dials the number.
If an unwanted number is
recognized by the system,
say Clear at any time to
clear the last number.
To hear all of the numbers
recognized by the system,
say Verify at any time and
the system will repeat them.
7-21
Advertisement
Chapters
Table of Contents
