Table of Contents
Advertisement
7-24
Infotainment System
To Transfer Audio to the In-Vehicle
Bluetooth System
The cellular phone must be paired
and connected with the Bluetooth
system before a call can be
transferred. The connection process
can take up to two minutes after the
key is turned to the ON/RUN or
ACC/ACCESSORY position.
During a call with the audio on the
cell phone, press
for more than
two seconds. The audio switches
from the cell phone to the vehicle.
Voice Pass-Thru
Voice Pass Thru allows access to
the voice recognition commands on
the cell phone. See the cell phone
manufacturers user guide to see if
the cell phone supports this feature.
Ofrecido por www.electromanuales.com
This feature can be used to verbally
access contacts stored in the cell
phone.
1. Press and release
system responds with Ready
followed by a tone.
2. Say Bluetooth . The system
responds with Bluetooth ready
followed by a tone.
3. Say Voice . The system
responds with OK, accessing
<phone name> .
The cell phone's normal
prompt messages will go
through its cycle according
to the phone's operating
instructions.
Dual Tone Multi-Frequency
(DTMF) Tones
The in vehicle Bluetooth system can
. The
send numbers and numbers stored
as name tags during a call. This is
used when calling a menu driven
phone system. Account numbers
can be programmed into the
phonebook for retrieval during menu
driven calls.
Sending a Number During a Call
1. Press and release
system responds with Ready
followed by a tone.
2. Say Dial . The system responds
with Say a number to send
tones followed by a tone.
. The
Advertisement
Chapters
Table of Contents
