Table of Contents
Advertisement
TracVision RV1 User's Guide
Receiver Settings
Check Switch Mode
44
When the Setup Wizard prompts you to run a Check Switch test for a
DISH Network or Bell TV configuration, the antenna automatically
enables Check Switch mode. In this mode, the antenna stops actively
tracking and stores the relative pointing position to each installed
satellite. Satellite switching is nearly instantaneous - the antenna just
shifts to the stored pointing positions. This rapid switching allows a
Check Switch test to pass on its first attempt. (The receiver assumes it
is connected to a stationary home antenna with multiple LNBs, so it
expects all satellites to be available at once.)
Important!
While in Check Switch mode, the antenna must remain motionless.
Since the antenna is not tracking the satellite in this mode, any
movement will throw off the relative pointing positions.
Keep the Check Switch mode set to Off (default setting) for normal
operation. Check Switch mode should only be set to On when you
need to run a Check Switch test on a receiver. You can change the
current Check Switch mode setting at the web interface (go to Settings
> General Settings).
Advertisement
Table of Contents
