Table of Contents
Advertisement
TracVision RV1 User's Guide
Antenna Settings
28
6. Using a 2mm Allen hex key, loosen (but do not remove) the
two M4 socket set screws securing the LNB to the reflector.
Figure 4-2 LNB Skew Adjustment
7. Rotate the LNB clockwise or counter-clockwise until the arrow
on the LNB points to the correct skew angle printed on the
choke feed.
NOTE: Be sure to keep the LNB fully inserted into the choke feed to ensure
optimum performance.
8. Tighten the set screws to secure the LNB in place. Apply
11 in.-lbs (1.2 N-m) of torque, if possible.
9. Reinstall the radome.
Advertisement
Table of Contents
