Sony LBT-ZUX10D Operating Instructions Manual page 84

There is excessive wow or flutter, or
the sound drops out.
• The capstans or pinch rollers are dirty
(see "Cleaning the tape heads" on
page 87).
Noise increases or the high
frequencies are erased.
• The record/playback heads are
magnetized (see "Demagnetizing the
tape heads" on page 87).
The tape does not record.
• No tape is loaded. Load a tape.
• The tab has been removed from the tape.
Cover the broken tab with adhesive tape
(page 87).
• The tape has reeled to the end.
When you press . or >, "Not in
Use" flashes in the display.
• The system does not have AMS
(Automatic Music Sensor) function.
This is not a malfunction.
The recorded sound has echo effect.
• Before you start recording, press
FLANGER, DELAY, CHORUS and
AQUA repeatedly to turn off the
effector mode.
Optional components
There is no sound.
• Refer to General item "There is no
sound." (page 78) and check the
condition of the system.
• Connect the component properly
(page 75) while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all
the way.
• Turn on the connected component.
• Refer to the operating instructions
supplied with the connected component
and start playing.
84 GB
If the system still does not operate
properly after performing the above
measures or other troubles not
described above occur, reset the
system as follows:
Use the buttons on the unit for the
operation.
1
Unplug the power cord.
2
Plug the power cord back in.
3
Press "/1 to turn on the system.
4
Press x, ENTER and "/1 at the
same time.
"COLD RESET" appears in the
display.
The system is reset to the factory settings
except for DVD settings. You should set
the settings you made, such as the preset
stations, clock and timer.
To return the DVD setup to the
default settings*, perform reset as
follows:
1
Press DISPLAY when playback
is stopped.
The Control Menu appears on the TV
screen.
2 V v
Press or repeatedly to select
(SETUP), then press
ENTER.
3 V v
Press or repeatedly to select
"RESET", then press ENTER.
4 V v
Press or repeatedly to select
"YES", then press ENTER.
It takes a few seconds to complete. Do
not press "/1 when resetting the
system.
* Except for Parental Control settings
Note
If you have connected an optional subwoofer,
turn off the subwoofer before you reset the
system.