Sony LBT-ZUX10D Operating Instructions Manual page 62

To change the sound movement
Press X-ROUND +/– repeatedly
X-ROUND JOG on the unit) to change the
sound movement from one speaker to
another speaker when
MANUAL FADER
BALANCE
To change the speed of sound
movement
Press X-ROUND +/– repeatedly
X-ROUND JOG on the unit)
speed of the sound movement when
AUTO WAVE, AUTO FADER and
AUTO BALANCE is selected.
To cancel the X-ROUND effect
Press X-ROUND ON/OFF repeatedly
until "X-ROUND OFF" appears in the
display.
"X-ROUND" lights off in the display.
Notes
• If you cannot get the sound effect you want,
check the speaker connections.
• The X-ROUND mode turns off automatically
when you
– connect the headphones.
– press SOUND FIELD.
– turn on the test tone.
• You cannot turn on the X-ROUND mode
when
– the headphones are connected.
– "SURROUND" in "SPEAKER SETUP" is
set to "NONE".
– test tone is performed.
• When the X-ROUND mode is turned on, the
audio output from the center speaker and
subwoofer is cut off.
62 GB
MANUAL WAVE
MANUAL
and
is selected.
to change the
Creating "MAX" or "JUMP"
(or turn
effect
— MAX/JUMP mode
,
You can use "MAX" to enhance the sound
and "JUMP" to switch the sound position
to the opposite direction instantly.
Creating the "MAX" and "JUMP"
(or turn
effect following the tempo of the
music
1
Press X-ROUND ON/OFF
repeatedly until "X-ROUND"
lights up in the display.
The last selected X-ROUND mode
appears in the display.
2
Press X-ROUND MODE
repeatedly to select the
X-ROUND mode you want.
3
Press MAX/JUMP MODE
repeatedly on the unit to select
"TEMPO".
"Hit MAX/JUMP PAD" flashes in the
display.
4
Press MAX PAD or JUMP PAD
once to start the tempo input.
5
By following the tempo of the
music, press MAX PAD or JUMP
PAD 4 times to input the tempo.
Each time you press MAX PAD (or
JUMP PAD), the flashing box will be
replaced with an "M" (or "J").
These effects are activated following
the input sequence and tempo
repeatedly.