Sony LBT-ZUX10D Operating Instructions Manual page 79

There is severe hum or noise.
• A TV or VCR is placed too close to the
unit. Move the unit away from the TV or
VCR.
• Move the unit away from the source of
noise.
• Connect the unit to a different wall
outlet.
• Install a noise filter (commercially
available) to the power cord.
The timer does not function.
• Check the timer setting and set the
correct time (page 69).
• Cancel the Sleep Timer function
(page 69).
• You cannot select the Play Timer and
the Timer Recording at the same time.
The remote does not function.
• Remove the obstacles between the
remote and the unit.
• Move the remote closer to the unit.
• Point the remote at the unit's sensor.
• Replace the batteries (R6/size AA).
• Move the unit away from the
fluorescent light.
There is acoustic feedback.
• Reduce the volume.
• Move the microphone away from the
speakers or change the direction of the
microphone.
The color irregularity on a TV screen
persists.
• Turn off the TV at once, then turn it on
after 15 to 30 minutes. If the color
irregularity still persists, place the
speakers farther away from the TV.
The sound from the component
connected to the TV/SAT AUDIO IN
L/R jacks is distorted.
• If "TV" appears in the display when you
press TV/SAT on the unit, switch to
"SAT" function (see "To switch
between the "TV" and "SAT" function"
on page 77).
The sound from the audio source has
echo effects.
• Press FLANGER, DELAY, CHORUS
and AQUA repeatedly to turn off the
effector mode.
There is beat sound even though you
have not played back any source.
• Press BEAT ON/OFF to turn off beat
pattern.
The light illuminated from the FRONT
BEAM is too glaring.
• Select "F.BEAM OFF" (page 71).
• Select "DIMMER 2" in BEAM
DIMMER (page 70).
• Do not stare at the FRONT BEAM
directly.
THEATRE SYNC function does not
work.
• If the distance between the TV and this
unit is too far, this function may not
work. Install the unit near the TV.
Speakers
Sound comes from one channel or
unbalanced left and right volume.
• Place the speakers as symmetrically as
possible.
• Check that the speaker are connected
securely and correctly.
• The source being played back is
monaural.
• Adjust the level of each speaker
(page 52).
• Turn off the X-ROUND mode
(page 62).
The sound comes from the center
speaker only.
• Depending on the disc, the sound may
come from the center speaker only.
l
Continued
79 GB