Changing The Display; Press V Or; Press; Repeatedly To Select "02 - Sony LBT-ZUX10D Operating Instructions Manual

When you record on both sides, be sure
to start from the front side. If you start
from the reverse side, recording stops
at the end of the reverse side.
7
Press "/1 to turn off the system.
Other operations
To
Check the setting
Change the
setting
Cancel the Play
Timer or
Recording Timer
Notes
• If you use the Play Timer or Recording Timer
and the Sleep Timer at the same time, the
Sleep Timer has priority.
• The Play Timer and Recording Timer will not
be activated if the system is turned on or if
"STANDBY" flashes in the display.
• The system turns on 30 seconds before the
preset time. For Recording Timer, do not
operate the system from the time the system
turns on until the recording starts.
• The volume is reduced to minimum during
Recording Timer.
70 GB
Do this
1
Press TIMER MENU.
"TIMER SELECT?"
flashes in the display.
2
Press ENTER.
V v
3

Press

or
repeatedly to select
"PLAY SELECT?" or
"REC SELECT?", then
press ENTER.
Start from step 1.
1
Press TIMER MENU.
"TIMER SELECT?"
flashes in the display.
2
Press ENTER.
V v
3
Press or
repeatedly to select
"TIMER OFF?", then
press ENTER.

Changing the display

Use the buttons on the unit for the
operation.
1
Press AMP MENU repeatedly to
select the item you want.
The last selected setting for the item
appears in the display.
SPECTRUM
Turn on or off the spectrum analyzer
display.
SYSTEM DIMMER
Adjust the brightness of the front panel
display.
BEAM DIMMER
Adjust the brightness of the built-in
beam.
ILLUMINATION
Select the pattern of the power
illuminator when the X-ROUND mode
is not selected.
X-ROUND ILLUM
Turn on or off the power illuminator
when the X-ROUND mode is selected.
2
Turn OPERATION DIAL to select
the setting you want.
3
Press ENTER.
Notes
• When you turn MASTER VOLUME (or press
VOLUME +/– on the remote), the power
illuminator shows the current volume level.
• During the demonstration display, you can
turn on or off the power illuminator and
built-in beam by pressing BEAM MODE.