Route Selected From The Routes List; How To Start Navigation From A Point On A Route - Furuno GP-1670F Operator's Manual

• A red line runs between the points on the route. The line shows the shortest path
to the destination and the direction to go.
Route point
(yellow by
default)
PT00003
• The arrival area, the radius of which is set with the arrival alarm, is shown with a red
dashed circle. When your boat comes within the circle or your boat moves through
an imaginary perpendicular line that crosses through the center of the destination
point, the audio alarm sounds and the arrival alarm icon appears at the top of the
screen to alert you. See the description on page 5-1.
• After you arrive to a point, the arrival area marker and the dashed line are switched
to the next waypoint.
5.3.2

Route selected from the Routes List

Open the [PLOTTER] menu and select [ROUTES] to show the [Routes List]. Select a
route and then press the ENT key to show the context-sensitive menu. Select [NAVI-
GATE] from the menu. See the description and figure in section 5.3.1 for the sequence
of events in route navigation. Note that the route points of a route created from the
[Routes List] are marked as "PTxxxxx".
5.3.3

How to start navigation from a point on a route

Depending on your position, objective, etc., you may want to skip some route points
on a route and start navigating directly to a specific point. Put the cursor on a route
point then press the ENT key to show the context-sensitive menu. Select [ACTIVATE
FROM] then press the ENT key.
PT00002
PT00001
Navigation line
Arrival area (red)
XTE alarm line
(red)
5. NAVIGATION
5-3