Wiring - Furuno GP-1670F Operator's Manual

13.5

Wiring

All wiring are terminated at the rear of the display unit. Refer to the interconnection
diagram on page S-1.
White
Black
Shield
Power cable
Connect the power cable to the power connector. Connect the leads to the battery (12
or 24 VDC); white to plus(+) terminal and black to minus(-) terminal. Ground the shield
to ship's ground.
Cable connector
Note: The fuse is not waterproof. Wrap the fuse holder with vinyl tape to keep water
out of the fuse holder.
Display unit (back)
No use
CAN bus
equipment
GPS antenna unit
GPA-017/017S
Power cable
w/fuse (3A)
Lead wire
White
Black
BATTERY
WARNING ELECTRICAL SHOCK
DO NOT touch the pins inside the
connector. Put the cap (supplied) on
the connector when power is off or
the transducer is disconnected.
Transducer
Shield
Ground
13. INSTALLATION
13-15