Xte Alarm; Temperature Alarm - Furuno GP-1670F Operator's Manual

8.4

XTE Alarm

The XTE (cross-track error) alarm warns you when your boat is off its intended course.
You must set a destination to use this alarm.
Own ship
position
Intended
course
To set the XTE alarm:
1. Open the [ALARMS] menu then select [XTE ALARM].
2. Confirm that the cursor is selecting the top line then push the RotoKey
3. Select [On].
4. Set the alarm value at [Distance].
5. Press the ESC/MENU key to close the menu.
8.5

Temperature Alarm

The temperature alarm, which requires water temperature data, alerts you to changes
in water temperature. There are two types of alarms: [Within] and [Outside]. The [With-
in] alarm sounds when the water temperature is within the range set, and the [Outside]
alarm sounds when the water temperature is higher or lower than the range set.
To set the temperature alarm:
1. Open the [ALARMS] menu then select [TEMPERATURE ALARM].
2. Confirm that the cursor is selecting the top line then push the
RotoKey
3. Select [Within] or [Outside] as appropriate.
4. Select [Min].
5. Set the minimum temperature.
6. Select [Max].
7. Set the maximum temperature.
Note: You can switch between plus and minus with the RotoKey
8. Press the ESC/MENU key to close the menu.
: Alarm area
TM
.
Destination
Alarm
waypoint
setting
8. ALARMS
TM
.
TM
.
8-3