Table of Contents
Advertisement
Programming
Your Telephone
Autodial Programming
Autodial is a feature that lets you:
l
Dial lengthy numbers using one or two buttons.
l
Store frequently used feature codes.
Autodial can be stored:
l
At a blank programmable button, or
l
On a secondary level under a DSS button.
Before you begin programming, write down:
l
The line(s) you will use to access the number.
l
The number or feature code you are storing.
As you program numbers, fill in the identification strips on your
telephone. Write first level numbers on the ID strips and secon-
dary numbers on the index pullout directory in the front of your
telephone.
Because the programming steps for outside numbers, intercom
numbers and feature codes vary slightly, they appear here as
separate steps.
Programming Outside Numbers
1.
2.
3.
4.
.
.
l
Press programmable button you want for storage.
Press your line button or 0 (for any line).
Dial the numbers to be stored:
You can enter up to 16 digits.
All digits on the keypad are valid.
You may need a pause between numbers to compensate
for differences in response time between your system and
the host system. If you do, press the HOLD button to insert
a pause. Then, continue dialing.
Continued
on
next page . . .
l
29
H-
Advertisement
Table of Contents
