Skoda 2013 Octavia A7 Owner's Manual page 31

Average fuel consumption
The average fuel consumption is calculated since the last time the memory was
1)
erased » page 30.
If you wish to determine the average fuel consumption over a certain period of
time, you must set the memory at the start of the new measurement to
zero » Fig. 10 on page 30.
After erasing the memory, no fuel consumption data will appear for the first
100 m driven.
The fuel consumption data is updated continuously while you are driving.
Current fuel consumption
You can use this information to adapt your driving style to the desired fuel con-
sumption .
1 )
The display appears in litres/hour if the vehicle is stationary or driving at a low
speed .
2)
Oil temperature
If the engine oil temperature is in the range 80-110 °C, the engine operating tem-
perature is reached.
If the temperature lies below 80 °C or above 110 °C, avoid high engine revs, full
throttle and high engine loads.
If the oil temperature is lower than 50 °C or if a fault in the system for checking
the oil temperature is present,  are displayed instead of the oil temperature.
Warning against excessive speeds
Set the speed limit, for example, for the maximum permissible speed in
town » page 31.
Traffic sign recognition
The display can show up to three of the following traffic signs simultaneously.
›
Maximum permissible speed (including additional signs).
›
Overtaking prohibited.
Further information » page 161, Traffic sign recognition.
1)
The units for the displayed consumption are set in the Infotainment
ment, chapter Device Settings.
2)
On some models in certain countries, the display appears in --,- kilometres/litres if the vehicle is sta-
tionary.
Current driving speed
The current speed is identical to the display on the speedometer
page 9.
Average speed
The average speed since the memory was last erased is shown in the display
in km/hour
To determine the average speed over a certain period of time, set the memory to
zero at the start of the measurement
After erasing the memory, no average speed data will appear for the first 300 m
driven.
The average speed data is updated regularly while you are driving.
Distance travelled
The distance driven since the memory was last erased appears in the display.
If you want to measure the distance travelled from a particular moment in time
on, at this moment, reset the memory by setting the button to zero
The maximum distance indicated is 9999 km. The indicator is automatically set
back to zero if this period is exceeded.
Driving time
The driving time which has elapsed since the memory was last erased, appears in
the display.
If you want to measure the time travelled from a particular moment in time on, at
this moment, reset the memory by setting the button to zero
The maximum distance indicated is 99 hours and 59 minutes. The indicator is set
back to zero if this period is exceeded.
Convenience consumers
The consumption display for the convenience consumers in l/h.
Together with the consumption display, a list of three convenience consumers
with the highest consumption is also displayed.
» Bedienungsanleitung Infotain-
» page 30.
» page 30.
» Fig. 2 on
3
» page 30.
» page 30.

29
Information system