Changing A Wheel - Skoda 2013 Octavia A7 Owner's Manual

WARNING
The factory-supplied lifting jack is only intended for your model of vehicle.
■
Under no circumstances attempt to lift heavier vehicles or other loads – risk of
injury!
Ensure that the vehicle tool kit is safely secured in the luggage compart-
■
ment.
Ensure that the box is always secured with the strap.
■

Changing a wheel


Introduction
This chapter contains information on the following subjects:
Preparation
Changing a wheel
Follow-up tasks
Loosening/tightening wheel bolts
Raising the vehicle
Securing wheels against theft
WARNING
If you are in flowing traffic, switch on the hazard warning light system and
■
set up the warning triangle at the prescribed distance! The national legal re-
quirements must be observed.
Park the vehicle as far away as possible from the flow of traffic. Park on as
■
flat and firm a surface as possible.
If the vehicle is subsequently fitted with tyres which are different from
■
those it was fitted with at the works, follow these guidelines
tyres.
WARNING
Observe the following instructions for lifting the vehicle.
If the wheel has to be changed on a slope, first of all block the opposite
■
wheel with a stone or similar object to prevent the vehicle from unexpectedly
rolling away.
Secure the base plate of the lifting jack with suitable means to prevent pos-
■
sible moving. A soft and slippery ground under the base plate may move the

lifting jack, causing the vehicle to fall down. It is therefore always necessary to
place the lifting jack on a solid surface or use a wide and stable base. Use a
non-slip base (e.g. a rubber foot mat) if the surface is smooth, such as cobbled
stones, tiled floor, etc.
Only attach the lifting jack to the attachment points provided for this pur-
■
pose.
Always raise the vehicle with the doors closed.
■
Never position any body parts, such as arms or legs under the vehicle, while
■
the vehicle is raised with a lifting jack.
229
Never start the engine with the vehicle sitting on the raised jack – risk of in-
■
230
jury.
230
231
CAUTION
231
232 The prescribed tightening torque of the wheel bolts for steel and light alloy
■
wheels is 120 Nm.
If the wheel bolts are fastened too tightly, it can cause damage to the anti-theft
■
wheel bolt and adapter.
Note
The anti-theft wheel bolt set and adapter can be purchased from a ŠKODA Part-
■
ner.
The national legal requirements must be observed when changing a wheel.
■
» page 222, New
Preparation

First read and observe the introductory information and safety warn-
ings
Always change a wheel on a level surface as far as possible.
The following steps must be carried out before actually changing the wheel:
on page 229.
Emergency equipment, and self-help


229