Batch Mode - Honeywell Xenon 1900 User Manual

Scan one of the bar codes below to set the scanner's power output to Full Power (100%), Medium Power (35%), Medium Low
Power (5%), or Low Power (1%). Default = Full Power.
Note: Setting a Granit scanner to anything lower than Full Power changes it to Class II Bluetooth.
* Full Power
Medium Low Power

Batch Mode

Batch mode is used to store bar code data when a scanner is out of range of its base or Access Point, or when performing
inventory. The data is transmitted to the base or Access Point once the scanner is back in range or when the records are man-
ually transmitted.
Note: Batch mode has limitations when using multiple scanners to one base or Access Point. If a cordless system is being used
in "multiple link mode," where up to 7 scanners are to be connected to one base or Access Point, some accumulated or
batched scans could be lost if scanners are constantly being moved in and out of range.
Automatic Batch Mode stores bar code data when the scanner is out of range of the base or Access Point. The data is auto-
matically transmitted to the base or Access Point once the scanner is back in range. When the scanner's buffer space is full,
any bar codes scanned generate an error tone. In order to scan bar codes again, the scanner must be moved back into range
of the base or Access Point so data can be transmitted.
Inventory Batch Mode stores bar code data, whether or not you are in range of the base or Access Point. To transmit the
stored data to the base or Access Point, either place the scanner in the base, or scan
When the scanner's buffer space is full, any bar codes scanned generate an error tone. In order to scan bar codes again, the
data must be transmitted to the base or Access Point. Once the data is transmitted, it is cleared in the scanner.
Persistent Batch Mode is the same as Inventory Batch Mode, except that once the data is transmitted to the base or Access
Point, it is retained in the scanner. If you want to transmit more than once, you can do so using this mode. In order to clear the
scanner's buffer, you must scan
Default = Batch Mode Off.
* Batch Mode Off
Clear All Codes (see page
Transmit Inventory Records
3-17).
Medium Power
Low Power
(page 3-17).
Automatic Batch Mode
3 - 13