Table of Contents
Advertisement
5.1 Selection of location for installation
(1) Indoor unit
(a)
Where there is no obstructions to the air flow and where the cooled
and heated air can be evenly distributed.
(b) A solid place where the unit or the wall will not vibrate.
(c)
A place where there will be enough space for servicing.
(Where space mentioned right can be secured)
(d) Where wiring and the piping work will be easy to conduct.
(e)
The place where receiving part is not exposed to the direct rays of
the sun or the strong rays of the street lighting.
(f)
A place where it can be easily drained.
(g) A place separated at least 1m away from the television or the radio.
(To prevent interference to images and sound.)
(h) Places where this unit is not affected by the high frequency equipment or electric equipment.
(i)
Avoid installing this unit in pace where there is much oil mist.
(j)
Places where there is no electric equipment or household under the installing unit.
(2) Wirless remote control
(a)
A place where the air conditioner can be received the signal surely during operating the wireless remote control.
(b) Places where there is no affected by the TV and radio etc.
(c)
Do not place where exposed to direct sunlight or near heat devices such as a stove.
(3) Outdoor unit
(a)
Where air is not trapped.
(b)
Where the installation fittings can be firmly installed.
(c)
Where wind does not hinder the intake and outlet pipes.
(d)
Out of the heat range of other heat sources.
(e)
A place where stringent regulation of electric noises is applicable.
(f)
Where it is safe for the drain water to be discharged.
(g)
Where noise and hot air will not bother neighboring residents.
(h)
Where snow will not accumulate.
(i)
Where strong winds will not blow against the outlet pipe.
(j)
A place where no TV set or radio receiver is placed within 5m.
(If electrical interference is caused, seek a place less likely to cause the problem)
(k)
If a operation is conducted when the outdoor air temperature is -5˚C lower, the outdoor unit should be installed at a place
where it is not influenced by natural wind.
(l)
Where it is likely that the unit is subjected to strong winds, provide wind guards according to the following guidelines.
Strong winds can cause performance degradation, an accidental stop due to a rise of high pressure and a broken fan.
1) Place the unit outlet pipe perpendicular to the wind direction.
2) Install so the direction of the air from the blowing outlet will be
perpendicular to the direction of the wind.
5 cm
Over 500mm
Wing direction
22
-
-
Left
side
Wing direction
Right
side
10 cm
Hide quick links:
Advertisement
Table of Contents
