Flap And Louver Control - Mitsubishi SRK50ZHX-S Technical Manual

4.5 Flap and louver control

Control the flap and louver by AIRFLOW
(1) Flap
Each time when you press the AIRFLOW
(Flap stopped)
• Angle of Flap from Horizontal
Remote control
display
COOL , DRY, FAN
HEAT
(2) Louver
Each time when you press the AIRFLOW
(Louver stopped)
(Swing)
• Angle of Louver
Remote control
display
Center installation
Right end installation
Left end installation
(3) Swing
(a) Swing flap
Flap moves in upward and downward
directions continuously.
S In HEAT operation
Approx. 45˚
Approx. 75˚
(4) Memory flap (Flap or Louver stopped)
When you press the AIRFLOW (UP/DOWN or LEFT/RIGHT) button once while the flap or louver is operating, it stops swinging
at the position. Since this angle is memorized in the microcomputer, the flap or louver will automatically be set at this angle when
the next operation is started.
(5) When not operating
The flap returns to the position of air flow directly below, when operation has stopped.
(UP/DOWN) and
(UP/DOWN) button the mode changes as follows.
Approx. 5˚ Approx. 20˚
Approx. 20˚ Approx. 35˚
(LEFT/RIGHT) button the mode changes as follows.
(Spot)
Left Approx. 50˚ Left Approx. 20˚
Left Approx. 50˚ Left Approx. 45˚
Left Approx. 20˚ Center
S In COOL, DRY, FAN operation
Approx.
5˚
Approx. 60˚
(LEFT/RIGHT) button on the wireless remote control.
Approx. 35˚ Approx. 45˚
Approx. 45˚ Approx. 60˚
(Wide)
Center Right Approx. 20˚
Left Approx. 30˚ Center
Right Approx. 30˚ Right Approx. 45˚ Right Approx. 50˚
(b) Swing louver
Louver moves in left and right directions continuously.
10
- -
(Swing)
Approx. 60˚
Approx. 75˚
Right Approx. 50˚
Right Approx. 20˚