Installing The Fin - Toshiba PORTÉGÉ Z930 Maintenance Manual

4 Replacement Procedures

Installing the Fin

To install the fin, follow the steps below and refer to Figure 4-14.
1. When silicon grease is already applied to the CPU, wipe them off with a cloth in
advance.
2. Apply new grease (Shin-Etsu Chemical Co. X-23-7921-5) on the CPU using a
special syringe as shown in the following figure.
NOTE: Apply new grease as shown in the figure below.
3. Set the fin in place and secure it with the following screws.
 M23.5C
NOTE: When securing the fin, be sure to secure the screws in the order of the number
marked on the fin.
4-32 [CONFIDENTIAL]
2
BIND
PORTÉGÉ Z930/Satellite Z930 Maintenance Manual (960-887)