Msata Ssd Troubleshooting; Note: Partition Check Cannot Be Performed In Diagnostics Disk (Cd); Procedure 1 Partition Check (Not Used) - Toshiba PORTÉGÉ Z930 Maintenance Manual

Troubleshooting Procedures
2.6

mSATA SSD Troubleshooting

To check if the mSATA SSD is malfunctioning or not, follow the troubleshooting procedures
below as instructed.
Procedure 1: Partition Check (Not Used)
Procedure 2: Message Check
Procedure 3: Format Check (Not Used)
Procedure 4: Diagnostic Test Program Execution Check
Procedure 5: Connector Check and Replacement Check
CAUTION: The contents of the hard disk will be erased when the 2.5"HDD
troubleshooting procedures are executed. Transfer the contents of the hard
disk to floppy disks or other storage drive(s). For the backup, refer to the
User's Manual.

2.6.1 Procedure 1 Partition Check (Not Used)

Insert the Toshiba DOS system disk and start the computer. Perform the following checks:

Note: Partition Check cannot be performed in Diagnostics Disk (CD)

Input C: and press Enter. If you cannot change to drive C, go to Check 2. If you
Check 1
can change to drive C, go to Procedure 2.
Input FDISK and press Enter. Choose Display Partition Information from the
Check 2
FDISK menu. If drive C is listed in the Display Partition Information, go to Check
3. If drive C is not listed, return to the FDISK menu and choose the option to
create a DOS partition or a logical DOS drive on drive C. If the problem still
occurs, go to Procedure 2.
Check 3 If drive C is listed as active in the FDISK menu, go to Check 4. If drive C is not
listed as active, return to the FDISK menu and choose the option to set the active
partition for drive C. Then go to Procedure 2.
Check 4 Remove the system disk from the FDD and reboot the computer. If the problem
still occurs, go to Procedure 2. Otherwise, the 2.5" HDD is operating normally.
2-36
PORTÉGÉ Z930/Satellite Z930 Series Maintenance Manual (960-887) [CONFIDENTIAL]