Table of Contents
Advertisement
7. Connection Procedure
This section describes the procedure for connecting the Code Reader to the Controller via
serial communications. This document explains the procedures for setting up the Controller
and the Code Reader from the factory default setting. For the initialization, refer to Section 8
Initialization Method.
7.1. Work Flow
Take the following steps to connect the Code Reader to the Controller via serial
communications.
7.2. Setting Up the Code Reader
↓
7.2.1. Cable Connection
↓
7.3. Setting Up the Controller
↓
7.3.1. Hardware Settings
↓
7.3.2. Starting the Sysmac Studio and
Importing the Project File
↓
7.3.3. Checking the Parameters and
Building
↓
7.3.4. Connecting Online and
Transferring the Project Data
↓
7.3.5. Transferring the Unit Settings
↓
7.3.6. Starting the CX-Protocol and
Opening the Protocol Macro
Data
↓
7.3.7. Connecting Online and
Transferring the Protocol Macro
Data
↓
7.4. Checking the Serial
Communications
↓
7.4.1. Starting the Trace
↓
7.4.2. Executing the Program
↓
7. Connection Procedure
Set up the Code Reader.
Connect a cable to the Code Reader.
Set up the Controller.
Set the hardware switches on the Serial
Communications Unit.
Start the Sysmac Studio and import the project file.
Check the parameters that are set, execute the
program check on the project data and build the
Controller.
Connect online with the Sysmac Studio and transfer
the project data to the Controller.
Transfer the setting data of the Serial
Communication Unit.
Start the CX-Protocol and open the protocol macro
data.
Connect online with the CX-Protocol, and transfer
the protocol macro data to the Serial
Communications Unit.
Execute the program and confirm that serial
communications are normally performed.
Start tracing with the CX-Protocol.
Execute the program with the Sysmac Studio.
13
Advertisement
Table of Contents
