Removal And Installation Of Carbonator; Carbonator Removal - Cornelius CB1522 Installation Manual

Removal and Installation of Carbonator

Carbonator Removal

1. Remove ice from bin.
2. Disconnect the power to the unit and to the pump and motor.
3. Shut off the CO
4. Shut off the water supply that is connected to the pump and motor.
5. Remove Cup Rest, Splash Panel, Drip Tray, Sliding Lid and Sanitary Plate.
6. Relieve pressure in the system by flipping the pressure relief valve to the up position on the Carbon-
ator.
7. Remove front cover, back cover and valve body of No. 8 (left side).
8. Remove the plug button on the left side of tower and cover hole with tape (safety).
9. Disconnect the barb fitting for the CO
10. Disconnect the barb fitting on the Carbonator lines to the coldplate tubes.
11. Disconnect probe wire from pump and motor harness.
12. Cut the silicone seal with putty knife around Carbonator a minimum of 1.5" deep and remove.
© 2003-2005, IMI Cornelius Inc.
supply that is connected to the Carbonator.
2
line on Carbonator.
2
- 21 -
IntelliCarb Drop-In Ice Cooled Installation Guide
Relief
Valve
Publication Number: 630460204INS