Cut Position Adjustment; Label Cut; Cutting Paper With Perforated Lines - SATO CT400i Series Quick Manual

Cut Position Adjustment

▲

Label Cut

The cut position when using labels is the designated cut position between labels on the blank area (the
area where there is only backing paper).
If the cut position is not the prescribed position, open the top cover and use the Philips head end of the
dial screwdriver attached to the printer unit to adjust the cut position.
Absolutely do not cut on top of the labels because the adhesive will stick to the cutter knife and cause
poor cutting.
Turn left: Stops the label behind the printing direction.
Turn right: Stops the label in front of the printing direction.
▲

Cutting paper with perforated lines

For paper with perforated lines, cutting on or in front of the perforated lines is prohibited.
Cutting in those locations could cause the printer to malfunction.
If cutting on or in front of the perforated line, use the Philips head end of the dial screwdriver
attached to the printer unit to adjust the [OFFSET] so that the cut is behind the perforated line.
The following items are specifications for paper that can be used by this printer, so check them
before using the printer.
(1) Paper thickness (including the backing paper) is 0.08 mm to 0.19 mm. For details contact
the store, dealer, or Support Center.
(2) Cut accuracy is ±1.5 mm.
(3) The cutter unit has a valid cut pitch of 20 to 400 mm. However, the cut size may be
restricted depending on the usage conditions.
(4) The perforated line +1 mm is the cut prohibited zone (Fig. 1).
(5) The folded perforated line +4 mm to +25 mm of fan folded paper is the cut prohibited zone
(Fig.2).
(6) After adjusting the volume, issue about 2 to 5 labels to stabilize the cut position.
18
(Fig. 1)
(Use the dial adjustment screwdriver.)
Cut prohibited
zone
(Fig. 1)
Labels
Backing
paper
Cut position
(Fig. 2)
25mm
Perforated
line
4mm
Folded perforated
line
(Fig. 2)