Ieee 1284 Interface - SATO CT400i Series Quick Manual

[Extension Interface(Option)]
¡IEEE 1284 interface
(1)When using an IEEE 1284 interface, set DSW 3-1 of the circuit
board on the bottom of the printer to ON.
(2)To set the printing support for the IEEE 1284 interface setting, set
DSW3-2 of the circuit board on the bottom of the printer.
For details regarding dip switch settings, refer to [Dip Switch
Settings].
/Page 29~31
¡Wireless LAN2 interface
No
Operation when the dip switch is ON and the printer power is turned on ((1) to (3)).
(1)
Not used
(2) Wireless LAN2 interface board setting information initialization
(3) Wireless LAN2 interface board setting information print/Self-diagnostic print
(Prints the setting information, such as IP address, and the wireless LAN2 interface
board diagnostic results.)
(4) Communication mode
(For wireless LAN operation)
When the LAN cable is connected and the power is turned on, the LAN interface starts up.
When the LAN cable is not connected and the power is turned on, the wireless LAN
interface starts up.
24
Wireless LAN2 interface
Wireless LAN2 interface board
OFF: Ad hoc
ON: Infrastructure
Connecting to a Computer

IEEE 1284 interface

Dip Switch Table
ON
(1)(2)(3)(4)