Loading the Carbon Ribbon
[Loading the Carbon Ribbon]
1
Press down on the open
lever (1) on the right side of
the printer to release the
lock and open the top cover
(2).
2
Pull the ribbon unit's [PULL]
mark to pull the ribbon unit
forward.
If the carbon ribbon width is over 92 mm and under 76 mm, use
Steps 3 to 6 to set the carbon ribbon.
For a carbon ribbon with a
width greater than 92 mm,
load the carbon ribbon
directly into the ribbon unit.
For a carbon ribbon with a
width under 76 mm, use a
ribbon adapter to load it into
the ribbon unit.
(2)
Ribbon adapter
(1)
[PULL] mark
19