Offset Position Adjustment - SATO CG408 Operator's Manual

8.6 OFFSET POSITION ADJUSTMENT

This setting adjusts the option (Cutter, Dispenser, Tear off) stop position after a print out.
The Offset position can be adjusted by using SATO Utilities Tool application or by sending command <PO>
from the host. The setting range is within ±99 dots. A positive value moves the leading edge of the label
forward (away from the print head) while a negative value moves the leading edge of the label back toward
the mechanism.
Adjustment for
"+" direction
Adjustment for
"-" direction
CG4 Series Operator Manual
Adjustment of Offset setting
Stop position for
cutting,dispense
or tear-off
Label feed direction
No
Adjustment
+99 (dot)
Base reference
position for printing
-99 (dot)
Section 8: Appendix
Page 8-9