Table of Contents
Advertisement
NOTE: If optional Ashtray is installed, it must be removed before installing the fan.
1) Remove the thumb screw from the fan transfer tray.
2) Slide fan transfer tray fully out through the bottom louver opening.
3) Mount the fan bracket onto the fan transfer tray using the two locating pins.
4) Slide the Control Box onto the Control Box Mounting Bracket located on the front of the fan transfer tray and secure with
the #8 x 3/8" screw
provided (refer to Diagram 1).
Thumb Screw
Locating Pins
Control Box
mounting bracket
Control
Box
5) Install the wiring as shown on the wiring diagram. Use the strength relief for running the wires from the fan transfer tray to
the receptacle box or the ground screw (refer to Diagram 2).
FAN
Note: Red wire not used.
6) Slide the fan transfer tray back into the unit and hook up wires to the Control Box.
FPI FP90 Wood Fireplace
918-437
fan installation
FAN INSTALLATION
The receptacle Box must be wired for the fan cable to be plugged into.
Diagram 1
NEUTRAL - FROM FAN [Black]
[Black]
Fan transfer tray
GROUND
[Green]
[Black]
installation
FP90
GROUND
Green
01/13/11
23
Advertisement
Table of Contents
