Milnor 30015V7J Service Manual page 37

Ê A pplying Threadlocker
NOTE: The following threadlocker information and
illustrations are excerpts from the Loctite
Guide and are used with permission.
For maximum strength, threadlocker must fill the thread
voids completely, as shown in FIGURE 2. Organic or petro-
leum solvent will remove excess uncured adhesive from
joints. Consult information below for the specific fastener ap-
plication.
B olts and Nuts Ë
—See FIGURE 3.
1. Clean all threads (bolt and nut) with cleaning solvent.
2. Spray all threads with Loctite
3. Insert bolt into through hole assembly.
4. Apply several drops of threadlocker onto bolt engage-
ment area.
5. Assemble and tighten nut to correct torque for the
threadlocker.
Ë B lind Holes
—See FIGURE 4.
1. Clean all threads (bolt and nut) with cleaning solvent.
2. Spray all threads with Loctite
3. Squirt several drops down female threads into bottom of
hole.
4. Apply several drops to bolt.
5. Tighten to correct torque for the threadlocker.
MSSM0101CE/9906AV (2 of 19)
®
User's
®
Primer N. Allow to dry.
®
Primer N. Allow to dry.
33
Î F IGURE 2
(MSSM0101CE)
C orrect Threadlocker Use Î
Apply here
Not here
F IGURE 3 Î
(MSSM0101CE)
Î A pplying Threadlocker to
Through Hole
Onto
threads
F IGURE 4 Î
(MSSM0101CE)
A pplying Threadlocker to Blind Holes Î
Onto
threads