Panasonic Lumix DMC-FZ28 Operating Instructions Manual page 33

u [VOLUME]
When you connect the camera to a TV, the volume of the TV speakers does not change.
•
[CUST. SET MEM.]
Refer to P89 for details.
•
\
[Fn BUTTON SET]
Refer to P57 for details about the review.
•
Refer to P116 for details about the [REC] Mode Menu.
•
[MONITOR/
VIEWFINDER]
[LCD MODE]
LCD
High angle mode is also cancelled if you turn the camera off or power save mode is activated.
•
The brightness of the pictures displayed on the LCD monitor is increased so some subjects
•
may appear differently from actuality on the LCD monitor. However, this does not affect the
recorded pictures.
The LCD monitor automatically returns to normal brightness after 30 seconds when recording
•
in Power LCD mode. Press any button to make the LCD monitor bright again.
If the screen is difficult to see because of light from the sun etc. shining on it, use your hand or
•
another object to block the light.
The number of recordable pictures decreases in Auto power LCD, Power LCD and High angle
•
modes.
Preparation
Adjust the volume of the speaker to any of 7 levels.
Up to 4 current camera settings can be registered as custom
settings.
(Recording mode only)
Assign [REC] Mode Menu to 4 button. It is convenient to register
[REC] Mode Menu that is used often.
[REVIEW]/[SENSITIVITY]/[WHITE BALANCE]/
[METERING MODE]/[AF MODE]/[I.EXPOSURE]
You can adjust the brightness of the monitor or the Viewfinder in
7 steps.
These menu settings make it easier to see the LCD monitor when
you are in bright places or when you are holding the camera high
above your head.
[OFF]
„ [AUTO POWER LCD]:
The brightness is adjusted automatically depending on how bright
it is around the camera.
... [POWER LCD]:
The LCD monitor becomes brighter and easier to see even when
taking pictures outdoors.
Å [HIGH ANGLE]
The LCD monitor is easier to see when taking pictures with the
camera held high above your head.
- 33 -