Keypad Commands - Planet VIP-281SW User Manual

The default IP address of LAN port is 192.168.0.1. (The WAN port is DHCP client mode.) You also
could open your web browser, and insert http://192.168.0.1 in the address bar of your web browser to
logon Router web configuration page.
To start Router web configuration, you must have one of these web browsers installed on computer for
management
•
Microsoft Internet Explorer 6.00 or higher with Java support
Please locate your PC in the same network segment
Note
(192.168.0.x) of Router. If you're not familiar with TCP/IP
please refer to related chapter on user's manual CD or
consult your network administrator for proper network
configurations.

Keypad commands

The Router series phone adapters support telephone keypad configurations, please connect analog
telephone set and refer to the following table for machine network configurations.
IVR Menu Choice Machine operation
Set DHCP client
#111#
#112xxx*xxx*xxx*
Setup Static IP Address
xxx#
#113xxx*xxx*xxx*
Set Network Mask
xxx#
#114xxx*xxx*xxx*
Set Gateway IP Address
xxx#
#115xxx*xxx*xxx*
Set Primary DNS Server
xxx#
Unlock
#190#
#195#
Save Network Settings
Parameter(s)
None
Use the * (star) key
when entering a decimal
point.
Use the * (star) key
when entering a decimal
point.
Use the * (star) key
when entering a decimal
point.
Use the * (star) key
when entering a decimal
point.
None
None
- 10 -
,
Notes
WAN port will change to
DHCP Client
DHCP will be disabled and
system will change to the
Static IP type.
Must set Static IP first.
Must set Static IP first.
Must set Static IP first.
Must unlock the protect
function before carry out
the firmware update
(#160#).
Must save network
settings after set up
network settings via
keypad.