Manual Test Mode - Whirlpool MVWC400XW Technical Education

FOR SERVICE TECHNICIANS ONLY
MANUAL TEST MODE — See page to access Manual Test Mode
Pressing the START button will activate/deactivate each output. When the output is activated, the
corresponding Status LED's will flash. NOTE: Lid must be closed and locked to perform SPIN tests.
OUTPUT
Output Details
NOTE: Outputs will time-out after 5 minutes.
LID LOCK
Lock and unlock the lid. NOTES: When lock is enabled, the "Lid Lock" LED will turn ON. Will only lock when lid is closed. Will only
unlock when basket RPM is 0. If lid is not closed, washer will beep and LED's will flash.
• If lid does not lock or unlock, go to TEST #8.
COLD VALVE
Turns ON and turns OFF cold water valve.
• If valve does not turn on, go to TEST #2.
HOT VALVE
Turns ON and turns OFF hot water valve.
• If valve does not turn on, go to TEST #2.
RESERVED FOR FUTURE DEVELOPMENT
If selected, washer will beep and LED's will flash.
RESERVED FOR FUTURE DEVELOPMENT
If selected, washer will beep and LED's will flash.
FABRIC SOFTENER DISPENSER
Turns ON and turns OFF the fabric softener valve. (May not be available on all models or brands.)
• If valve does not turn on, go to TEST #2.
OXI DISPENSER
Turns ON and turns OFF the Oxi dispenser valve. (May not be available on all models or brands.)
• If valve does not turn on, go to TEST #2.
DRAIN
Turns ON and turns OFF the drain pump.
• If pump does not turn on, go to TEST #7.
RESERVED FOR FUTURE DEVELOPMENT
If selected, washer will beep and LED's will flash.
LOW SPIN
Allow up to 15 seconds for shifter to reposition. Spins basket from 0 to 500 RPM.
IMPORTANT: Water in tub must be drained before test. IMPORTANT: To activate Low Spin, RPM must read "0" and lid must be
closed with lid lock enabled. If lid is not closed, washer will beep and LED's will flash.
• If motor does not spin, go to TEST #3a & 3b.
HIGH SPIN
Allow up to 15 seconds for shifter to reposition. Spins basket from 0 to maximum RPM.
IMPORTANT: Water in tub must be drained before test. IMPORTANT: To activate High Spin, RPM must read "0" and lid must be
closed with lid lock enabled. If lid is not closed, washer will beep and LED's will flash.
• If motor does not spin, go to TEST #3a & 3b.
GENTLE AGITATION
Allow up to 15 seconds for shifter to reposition. Shifts from idle motor to gentle CW/CCW agitation.
IMPORTANT: To activate Gentle Agitation, RPM must read "0" and lid must be closed with lid lock enabled. If lid is not closed,
washer will beep and LED's will flash.
• If motor does not agitate, go to TEST #3a & 3b: Drive System (Shifter & Motor).
HEAVY AGITATION
Allow up to 15 seconds for shifter to reposition. Shifts from idle motor to heavy CW/CCW agitation.
IMPORTANT: To activate Heavy Agitation, RPM must read "0" and lid must be closed with lid lock enabled. If lid is not closed,
washer will beep and LED's will flash.
• If motor does not agitate, go to TEST #3a & 3b: Drive System (Shifter & Motor).
STATUS LEDs
On
On
On On
On On On
On
On
On
On
On On
5-9
DISPLAY
If Available
00
01
On
02
On
03
On On
04
05
On
06
07
08
09
On On
10
On On
To activate High Spin,
1 1
On
On On
12
On