Automatic Test Mode - Whirlpool MVWC400XW Technical Education

FOR SERVICE TECHNICIANS ONLY
AUTOMATIC TEST MODE — See page to access Automatic Test Mode
Press the START button to begin the Automatic Test. NOTE: Lid must be closed with lid lock
enabled to perform Automatic Test.
FUNCTION
Recommended Procedure
LID WILL LOCK
Motor must be at "0" RPM. If lid does not lock, go to Manual Test.
COLD VALVE WILL ACTUATE
If water is not present, or temperature is wrong, go to Manual Test.
HOT VALVE WILL ACTUATE
If water is not present, or temperature is wrong, go to Manual Test: Hot Valve.
RESERVED FOR FUTURE DEVELOPMENT
Washer will pause for 5 seconds.
RESERVED FOR FUTURE DEVELOPMENT
Washer will pause for 5 seconds.
FABRIC SOFTENER DISPENSER & COLD VALVE WILL ACTUATE
If no water in fabric softener dispenser, go to Manual Test: Fabric Softener Dispenser.
HOT & COLD VALVE WILL ACTUATE
Hot & cold water valves will actuate for the specified time period.
SHIFTER MOVES TO AGITATION POSITION
If motor does not agitate, go to Manual Test: Gentle or Heavy Agitation.
MOTOR AGITATES
If motor does not agitate, go to Manual Test: Gentle or Heavy Agitation.
DRAIN PUMP WILL ACTUATE
If water is not draining, go to Manual Test: Drain.
SHIFTER MOVES TO SPIN POSITION
If basket is not turning, go to Manual Test: Low or High Spin.
MOTOR SPINS
If basket is not turning, go to Manual Test: Low or High Spin.
LID REMAINS LOCKED UNTIL WASHER SENSES A STOPPED
BASKET
Basket must stop spinning (0 RPM) before test continues to next phase. Time for basket to stop spinning may vary from
seconds up to 2 minutes.
LID WILL UNLOCK AND CYCLE COMPLETES
If lid does not unlock, go to Manual Test: Lid Lock. If no end-of-cycle tone, make sure Cycle
Signal is turned on.
STATUS LEDs
On
On On On
On
On
On On
On On On On
On
On
On On
On On On On
On On
On On
On On On
5-8
DISPLAY Est. TIME
If Available In Seconds
01
On On 1
02
On 5
03
5
04
On 5
05
On On 5
06
On 5
07
45
08
On ~5-15
09
On On 10
10
On ~30-40
1 1
~5-15
12
On 10
13
On On ~30-40
m 30
14
1
Estimated
~3 min
Time